Handyvideoarchiv

How to Install Nano Ganesh to the starter ? 1.Install Nano Ganesh unit in the starter panel. 2.In case of DOL starter, Nano Ganesh can be directly connected to the starter. 3.For higher HP, the pumps are started by star delta starter. In that case ensure that the starter is fully automatic. 4.For the mobile setting refer to the mobile phone setting given separately. 5.Put charger of the mobile phone in the socket of Nano Ganesh. 6.For connections and wirings of the Nano Ganesh, follow the procedure below: 7.Refer to the wiring diagram as well as single line diagram. How to test Nano Ganesh ? 1.Get the settings of a mobile phone done referring to the separate sheet… 2.Make power supply off. 3.Insert a headset pin of Nano Ganesh into a mobile phone. 4.Observe, a sign of headset on the mobile phone. 5.If headset sign is not visible, retry the headset pin fitting properly into a mobile phone. There are different configurations of headset pins for different mobile phones. We have given two units with two different configurations which work fine for NOKIA models. You may try any one model for your desired NOKIA phone and repeat it for other unit. 6.After a sign of headset is visible on the mobile phone, make power supply to the system on. ( In this case a main switch of 3-ph ) 7.The red indicator on Nano Ganesh will be on. It is MAINS ON indicator. 8.Press on the digit 6 or 9 on the mobile phone connected to the device. It will turn on the green indicator and it will give a …